Once a week
Turn the Dyson AM10 humidifer into standby mode/'OFF'.
Unplug from the mains electricity supply.
1
Wipe over air loop amplifier, paying close attention to the
air gaps. Wipe with a lint-free microfibre cloth.
2
Empty the water. Rinse and wipe over all surfaces.
Repeat if necessary.
3
Empty the trough of any water, small spillages may occur.
While not dangerous, care should be taken to avoid
water entering the inlets. Clean thoroughly, using the
recommended citric acid solution. Do not rinse under
the tap or put in a dishwasher. Fill the trough with the
recommended citric acid solution until the UV-C emitter
and piezo are submerged. Leave for 15 minutes. Drain,
rinse and wipe over all surfaces. Repeat if necessary.
19