Function „Zoom; Function „Upgrade - Renkforce 808578 Notice D'emploi

Function „Zoom"
Activate a digital zoom with this to indicate the video display of the radio camera twice as large. If the
enlarged image of the radio camera is displayed, you can move the visible image section with the four
arrow buttons.
Proceed as follows:
• Use the buttons „4" and „6" to choose the submenu „Zoom" and then push the button „PLAY/ENTER"
on the DVR or the button „
• Use the buttons „4" and „6" to switch between „x1" (normal display) and „x2" (zoom).
• Confirm selection with the button „PLAY/ENTER" on the DVR or the button „
rol.
• Push the button „MENU/ESC" on the DVR or the button „MENU" on the IR remote control repeatedly to
return to the respective previous menu or leave the OSD menu.
The volume cannot be set in zoom mode, since the arrows are used to move the visible section
of the screen here. Briefly switch to the quad or auto mode (see chapter 10 d) and then set the
volume as desired.
Function „Upgrade"
This function is used to perform a firmware upgrade by the manufacturer.
If there is a firmware upgrade available for the DVR, it is provided at www.conrad.com on the respective
product page with a description for the precise procedure.
62
" on the IR remote control.
" on the IR remote cont-