Submenu „Camera Setup; Function „Activation; Function „Brightness - Renkforce 808578 Notice D'emploi

After starting the OSD menu with „MENU/ESC on the DVR or the button „MENU" on the IR remote control",
four different submenus/functions can be selected („Camera Setup", „Record Setup", „System Setup" and
„Play Back") that are described in the next section.
c) Submenu „Camera Setup"
In the OSD menu, use the buttons „4" and „6" to choose the submenu „Camera Setup" and then push the
button „PLAY/ENTER" on the DVR or the button „
Function „Activation"
Unused channels can be switched off here, e.g. when using only two radio cameras/channels (the DVR
permits use of up to four radio cameras/channels). In single-quad or auto mode (see chapter 10. d), the
deactivated channels are not displayed.
Proceed as follows:
• Use the buttons „4" and „6" to choose the submenu „Activation" and then push the button „PLAY/
ENTER" on the DVR or the button „
• Use the buttons „8" and „2" to select one of the four channels („CAM1", „CAM2", „CAM3" or „CAM4";
it is marked yellow each.
• Push the button „PLAY/ENTER" on the DVR or „
from yellow to red.
• Switch the channel on or off with the buttons „4" and „6" („ON" = switched on, „OFF" = switched
off).
• Confirm selection with the button „PLAY/ENTER" on the DVR or the button „" on the IR remote control.
• Push the button „MENU/ESC" on the DVR or the button „MENU" on the IR remote control repeatedly to
return to the respective previous menu or leave the OSD menu.
Function „Brightness"
In this function, the screen brightness for each radio camera/channel can be set separately.
Proceed as follows:
• Use the buttons „4" and „6" to choose the submenu „Brightness" and then push the button „PLAY/
ENTER" on the DVR or the button „
• Use the buttons „4" and „6" to pick one of the four channels now.
• Push the button „PLAY/ENTER" on the DVR or „
image of the respective channel.
• Set the desired brightness with the buttons „4" and „6".
• Push the button „MENU/ESC" on the DVR or the button „MENU" on the IR remote control repeatedly to
return to the respective previous menu or leave the OSD menu.
54
" on the IR remote control.
" on the IR remote control.
" on the IR remote control to make the mark switch
" on the IR remote control.
" on the IR remote control to display the camera