Commissioning; Inserting Batteries In The Ir Remote Control, Battery Replacement; Dvr - Renkforce 808578 Notice D'emploi

9. Commissioning

a) Inserting Batteries in the IR Remote Control, Battery Replacement
The IR-remote control needs a battery type „CR2025".
At initial commissioning, the battery is already in the battery compartment of the IR remote cont-
rol. A plastic strip protects the battery from discharge.
Pull out the plastic strip to make the IR remote control operational.
A battery change is required if the range of the IR remote control drops or the DVR no longer reacts to the
IR remote control at all.
To perform the battery change, the locking clip at the battery compartment must be unlatched, e.g. with a
flat screwdriver, upon which the battery holder and battery can be pulled out.
Replace the empty battery with a new one of type „CR2025". Always observe the correct polarity (plus/+
and minus/-) when inserting the battery. The plus pole of the battery is marked with the icon „+" and must
point towards the bottom of the IR remote control.
Push the battery holder back into the IR remote control. Observe correct orientation. Do not apply any
force!
Dispose of the flat battery in an environmentally compatible manner; see chapter „Disposal".
b) DVR
• First screw on the (black) aerial at the top of the DVR. The aerial can be raised vertically or tilted and
aligned in the 45° and 90° angle to improve reception.
• Place the DVR on a level, firm, and sufficiently large area. Protect expensive furniture surfaces from
impressions and scratches and discolouration with suitable pads.
• Connect the video output of the DVR (cinch socket „Vout" (4) at the rear) to the video input of your
screen.
• Connect the audio output of the DVR (cinch socket „Aout" (3) at the rear) to the audio input of your
screen.
Use, e.g., the enclosed AV cable to connect the video and audio output of the DVR.
• Connect the low-voltage round plug of one of the two enclosed plug-in mains adapters to the correspon-
ding socket (2) of the DVR.
The two enclosed plug-in mains adapters are of the same build; therefore, it does not matter
which one you use.
Plug the plug-in mains adapter into a proper mains socket of the public mains.
• Switch on the DVR via the slider (1) („ON" = activated, „OFF" = deactivated). The LED (6) should now be
lit blue.
• Insert a SD/SDHC memory card (max. 32GByte) into the memory card slot (8) of the DVR so that it latches.
With the memory card inserted, a small „SD" icon appears at the upper left of the display of the connec-
ted screen/TV.
48