Configurations; Technical Data; Service Conditions - IGF 2700/PL10/8 Mode D'emploi Et D'entretien

3.3. CONFIGURATIONS

For the detailed technical data, the production and the mechanical drawings, cfr. annexed.

TECHNICAL DATA

FIXED HEAD
TIP UP HEAD
FIXED BOWL
REMOVABLE BOWL
ROUNDED BOWL EDGE
FLAT EDGE BOWL EDGE
SPIRAL TOOL
SPATULA TOOL
FIXED TOOL
INTERCHANGEABLE TOOL
UNIQUE MOTOR FOR BOWL AND TOOL
A MOTOR FOR BOWL AND ONE FOR TOOL
ELECTROMECHANICAL CONTROLS
ELECTRONIC CONTROLS WITH STOP DELAY TIMER
ELECTRONIC CONTROLS WITH TIMER FOR SPEED SWITCHING

3.4. SERVICE CONDITIONS

DATA
Level of acoustic power continue equivalent weighted A
Current nature – Frequency
Current full charge value
Use nominal voltage
Allowable presumed current of nominal short circuit
conditioned
Mass and neutral
Protection degree
Machine positioning
Use place
Maximum temperature of the work environment air
Requested minimum lighting
Further use conditions
PROTECTION DEVICE RECOMMENDED AGAINST THE OVERCURRENTS
Insulation nominal voltage
Nominal current
Magnetic relay setting
Thermal relay setting
Maximum value of the damage ring impedance
10-2009-IMPASTATRICE-ART 2700-A5.doc
ART. 2700
Work bench used in the food field of height included
between 900/1100mm from the trampling floor of
adequate capacity, in which it is possible to circulate freely
around the machine with a free space of at least 800mm
Inadequate machine for functioning in environments
where there are contaminated agents: for example
powders, acids, corrosive gas, salts and similar.
Inadequate machine for functioning in environments
where there are potentially explosive atmospheres
classified as zone 0 or zone 1 or zone 2.
Inadequate machine for functioning in environments
where there are ionized and not ionized radiations: for
example microwaves, ultraviolet rays, lasers, X rays and
similar.
Inadequate electric equipment to be equipped with
machines or to function in environments where there are
vibrations and shocks: in contrary case assembly it far
from the device and foresee antivibrating supports
In = > see electric diagram
Im = < see electric diagram
Ir = see electric diagram
ORIGINAL INSTRUCTIONS TRANSLATION
ART- 2700
Minor of 70dBA
Cfr. machine plate
Cfr. machine plate
Cfr. machine plate
6 kA symmetric
TT e TN
IP X3
Inside
+40°C
500 lux
Ui = > 690 V
0.1 Ω
Pag. di
9 30