Removing And Replacing The Trimmer Head - Oregon ST250 Manuel D'instructions Original

OREGON® Cordless Tool System
TRIMMER/EDGER MODEL ST250
• Line up the tabs on the cover (1) with the
eyelets on the housing (2) so that the
triangular notch on the cover (3) is near
the release tab (4), then turn the cover
clockwise until it locks into place (Fig 27)
Fig. 27
(1)
(2)
IMPORTANT: MAkE SURE ALL THREE
TABS ARE IN POSITION AND THAT
THE COVER IS LEVEL AND WELL-
SEATED (FIG. 28).
Fig. 28
COrrECT ALigNMENT
MiSALigNED
• Turn the trimmer head by hand and
make sure the cover rotates evenly If it
rotates unevenly, remove and replace
the cover so it is level with the rest of the
trimmer housing
AE 1212 - F/N 558937
REMOVING AND REPLACING
THE TRIMMER HEAD
If the trimmer head is cracked or broken,
it should be removed and replaced with
a new one Also, if there is buildup of
clippings between the trimmer head and
the guard, it is easier to clean them if the
trimmer head is removed first
Insert a screwdriver into the trimmer
head lock above the guard to keep the
(1)
spindle from turning (Fig 29)
(3)
(2)
(4)
Turn the trimmer head counter-clockwise
until it comes off of the spindle (Fig 30)
To replace, with the screwdriver still in the
hole, thread the head onto the spindle
and turn clockwise until it stops
MAiNTENANCE AND CLEANiNg
Fig. 29
Fig. 30
23