SPIT P18 Notice Originale page 19

SPIT P18 Lithium
Specified conditions of use
The device is designed exclusively for driving
screws into and loosening
plasterboard and chipboard on wood and sheet
steel substructures.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
Technical data
Rated voltage of battery in V DC
Capacity in Ah
1. n = No-load speed (1st gear)
0
in rpm
max. torque
Nm
max.
Noise levels
L = A-rated sound pressure level
pA
L = A-rated sound power level
wA
K = Measurement uncertainty value
The noise level can exceed 85 dB(A)
during operation.
Wear hearing protection!
Triaxial vibration
determined in accordance with EN
62841.
K = Measurement uncertainty value
The vibration emission level given
in this information sheet has been
measured in accordance with a
standardised
62841 and may be used to compare
one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this
information sheet. This
underestimation of vibration when the tool is used
regularly in such a manner.
Note: To be accurate, an estimation of the level
of exposure to vibration experienced during a
given period of work should also take into
account the times when the tool is switched off
and when it is running but not actually when
doing the job.
screws from
emission level
test given in EN
could lead to
This may significantly reduce the exposure level
over the total working period. Identify additional
safety measures to protect the operator from the
effects of vibration such as: maintain the tool and
accessories, keep the hands warm, organisation
of work patterns.
Fitting screws in wood - max. ø in
mm
Weight in kg
Battery
Battery Li-ions
Rated voltage of battery V DC
Capacity in Ah
Battery Charger
Mains voltage in V~
Frequency in Hz
Charging voltage in V DC
Charging current in A
Operating temperature range in °C
Battery charging time in min.
Your battery charger is double-
insulated in accordance with EN
60335. For this reason an earth wire
is not required.
4. Operation
Remove the battery from the device before
undertaking any work on the device.
This safety measure prevents accidental starting of
the power tool.
English
19