Water Use - Maytag MAH-3 Guide D'utilisation

U C
SING THE ONTROLS
E T
STIMATED IME
After setting the cycle and pressing Cycle Selector dial, the display will show the esti-
mated minutes remaining in the cycle.The estimated time remaining may fluctuate to bet-
ter indicate the wash time left in the cycle.
I L
NDICATOR IGHTS
Door Lock – lights whenever the door of the clothes washer is locked.The door can
be unlocked by pressing the Cycle Selector dial to pause the washer.
Control Lock – The washer controls can be locked to prevent unwanted use by chil-
dren.
1. Press the Wash/Rinse Temp and Spin Speed pads at the same time for
three seconds.
2.The Control Lock light will illuminate.
3.To unlock, press the Wash/Rinse Temp and Spin Speed pads at the same
time for three seconds.The Control Lock light will go out.
Cycle Indicator Lights – The Wash, Rinse and Spin lights at the top of the control
panel will illuminate progressively to indicate when the washer is in those portions of the
cycle.These lights will flash when the cycle has been paused.
Pad Indicator Lights – The indicator lights above the pads will illuminate when the
pad is selected.
Cycle Setting Indicator Lights – Indicator lights by the cycle settings will illuminate
when the selection is made.
W U
ATER SE
I F TM W
NTELLI ILL
The amount of water used will vary with each load.The Maytag Neptune
will automatically provide the appropriate amount of water for efficient cleaning perform-
ance and conservation of water and energy. Fill time will vary depending on water pressure.
D
(
ISPLAY
SELECT MODELS
L C
ATER EVEL ONTROL
)
clothes washer
®
8
Control features vary by model.