EINHELL BT-BC 22 E Mode D'emploi page 14

Anleitung_BT_BC_22_E_SPK1:_
GB
10. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults. In the
event of any malfunctions or faults, please check the following before you contact your customer services.
Fault
Overload cut-out trips - Charger clamps connected
incorrectly
- Contact between the charger
clamps
- Battery highly discharged
- Battery defective
Charging current indicators does - Poor contact between the
not work charger clamps and battery
poles
- Battery defective
- Defective charging current
indicator
14
03.12.2010 9:58 Uhr
Possible cause Remedy
- Connect the red clamp to the
positive pole and the back clamp
to the bodywork
- Prevent contact
- Select a lower charging current
- Have the battery checked by an
expert and replace it if necessary
- Clean the contacts and charger
clamps
- Have the battery checked by an
expert and replace it if necessary
- Check the function of the
equipment using a different
battery
Seite 14