Epson PowerLite W16SK Guide D'installation page 9

Caution
When attaching the
commander to the
receiver, be careful not to
trap your fingers.
Attach the commander to the receiver by sliding the commander's
stacking mount screws into the slots in the receiver's stacking mount.
Then lightly tighten the screws (on both the left and right sides) to secure
the attachment.
4 Secure the stacking mount angle adjustment with screws.
There are screw holes
numbered 1 to 4 on
the left and right of the
stacking mount.
You can change the
commander's projection
angle by changing the
position secured by the
screw.
Place the screws into the holes, and then tighten them securely (on both
the left and right sides). Then tighten the commander's stacking mount
See "Screen Size and
screws as well.
Projection Distance"
on page 18 to determine
which screw hole to use.
5
Place marking
stickers on the
positions where the
screws are secured. You
can then use these marks
when reassembling.
Remove the clear
protective film from the
polarizing filters.