Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
About the LED Indicators
The LED indicators change according to the status of the commander and the receiver. For more troubleshooting information, see your online User's Guide.
On
Flashing
Off
Indicator status during normal operation
Standby
Orange
Warm-up in progress
Green
Projection in
Green
progress
Indicator status during an error/warning
Red
Internal Error
Red
Red
Red
Fan Error
Sensor Error
Red
High Temp Error
Wait for about five
Red
minutes, and then
disconnect the power
Red
cable from the electrical
outlet.
Red
High Temp Warning
Orange
Press
to start projection.
is unavailable for about 30 seconds.
The projector is operating normally.
Disconnect the power cable from the electrical
outlet, and contact Epson.
Check the following points.
•
If the projectors are positioned next to a wall,
move them farther away from the wall.
•
Clean or replace the air filter.
•
Make sure nothing is blocking the vents.
Lamp Error
Red
Lamp Failure
Red
Replace Lamp
Orange
Red
Auto Iris Error
Red
Power Error
Red
If the error continues to occur after checking the points above, disconnect the power cable from
the electrical outlet, and contact
Epson
.
Check the following points.
•
Remove the lamp and check that it is not
damaged. If it is not damaged, reinstall the
lamp and turn on the projector. If it is damaged,
contact Epson.
•
Check that the lamp and the lamp cover are
securely installed.
•
Clean the air filter.
Replace the lamp as soon as possible. The lamp
may fail if you continue to use it in this condition.
Disconnect the power cable from the electrical
outlet, and contact Epson.
Epson. .
19
Publicité
Table des Matières
