Epson PowerLite W16SK Guide D'installation page 8

Setting Up
Stacking and
installing the
commander and the
receiver
Use the stacking
mounts to create a
stacked configuration
(one projector on top of
the other).
Secure the polarizing filters for
the commander and the receiver
with the supplied screws. Do not
overtighten the screws.
    
1
Warning
When assembling a
stacked configuration,
make sure you follow
these steps. If the
the projectors, stacking
steps are not followed
mounts, and polarizing
correctly, the product
filters. Make sure the
could fall, or your fingers
numbers match when
could get caught, which
assembling.
could cause an injury.
Attach the feet (when
2 3
setting up on a desk).
Attach the front foot and the rear Carefully remove the protective
feet to the base of the receiver. tape from the stack angle
Turn the feet to extend and adjustment screws, and then
retract to adjust the horizontal remove the screws (on both the
tilt. left and right sides).
Attach the polarizing filters to the commander and the receiver.
There are numbers
on the bases of
Turn over the commander and the receiver, and then attach the polarizing
Commander
filters.
Press until they click into place.
Receiver
Stack the commander on top of the receiver.
Loosen the screws for the commander's stacking mount connector (on
both the left and right sides).