Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Correct keystone distortion for the receiver's frame (green).
Correcting using
H/V-Keystone
Select H/V-Keystone.
Use the [
] [
] [
] [
]
buttons to select the corner you
want to correct, and then press
the [
] button.
16
16
16
16
16
Use the [
] [
] buttons to
select the direction you want
to correct, and then press the
[
] [
] buttons to make
corrections.
Press the [Esc] button to finish
Use the [
] [
] [
] [
]
making settings.
buttons to correct the position of
When you have finished making
the corners.
corrections, press the [Esc]
Correct each corner as necessary.
button until you see the initial
adjustment screen again.
Press the [Esc] button to finish
making settings.
When you have finished making
corrections, press the [Esc]
button until you see the initial
adjustment screen again.
8
Adjust the projection size for the commander's frame
(white).
Commander
frame
Use the commander's zoom ring
to adjust the commander's frame
(white) so that it is outside the
receiver's frame (green).
Correct the four corners of the receiver's
Correcting using
frame (green) individually.
Quick Corner
Select Perform keystone
correction for the Receiver.
Receiver
•
For best results, minimize the
frame
difference in size between
the receiver's frame (green)
and the commander's frame
(white).
•
The images can still be
superimposed even if the
commander's frame is outside
the screen.
•
If you have trouble adjusting
the frames, make sure you
selected the correct screw hole
when you adjusted the angle
between the projectors. See
"Screen Size and Projection
Distance" on page 18 to
determine which screw hole
to use.
Select Quick Corner.
Publicité
Table des Matières
