Before Operating; Air System - Concept CAC150RK Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETUP & OPERATION
SETUP & OPERATION
EXTENSION CORDS
NOTE: If you plan to use an extension cord when operating your air compressor,
please note:
 Maximum length: not to exceed 25 ft.
 Minimum wire size: 14 gauge.
If the extension cord is too long or the wire size is too small, the air compressor will
not start.

BEFORE OPERATING:

 Check that all nuts and bolts are snug.
COMPRESSOR INITIAL BREAK-IN
NOTE: This is an oil-free compressor and DOES NOT require oil to operate
CAUTION: Do not attach air tool accessories or tools to open end of hose until start
up has been completed and unit checks OK.
1. Turn regulator fully clockwise to open airfl ow.
2. Turn switch to OFF position and plug in power cord.
3. Turn switch to ON position and run unit for 5 minutes to break in the pump parts.
4. Turn regulator knob fully counterclockwise. Compressor will build to maximum
preset pressure and shut off.
5. Turn regulator knob clockwise to cause air to bleed off. Compressor will restart
at a preset pressure.
6. Turn regulator knob counterclockwise to shut off the air and turn switch to off
position.
7. Attach chuck or other tool to open end of hose. Turn the regulator on. In the ON
position, the compressor pumps air into the tank. It shuts off automatically when
unit reaches its maximum preset pressure. In the OFF position, the pressure
switch cannot function and the compressor will not operate. Make sure switch
is in OFF position when connecting or disconnecting power cord from electrical
outlet.
8. After 2 weeks, tighten all nuts and bolts, including head bolts.

AIR SYSTEM

 The brad nailer is designed to operate on clean, dry, compressed air, regulated
at 60-100 psi / 413 to 690 kPa / 4.13 to 6.9 bar. The preferred system would
include a fi lter, a pressure regulator, and an automatic oiler located as close to
the tool as possible (within 15 feet / 5 meters is ideal). Do not use bottled air or
gases. Please see fi gure below:
Nailer
Quick Connector
MAINTENANCE
Oiler
Air Hose
Filter
Regulator
!
!
Air Supply
Air Supply

Publicité

Table des Matières
loading

Table des Matières