Concept CAC150RK Manuel De L'utilisateur page 3

IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS
14. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can fl y off
a rotating part and result in personal injury.
15. DO NOT USE THE COMPRESSOR IF IT CANNOT BE SWITCHED ON OR
OFF. Have it repaired before using it.
16. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY ADJUST-
MENTS. Changing attachments or accessories can be dangerous if the tool
could accidentally start.
COMPRESSED AIR CAUTIONS COMPRESSED AIR CAUTIONS
1. COMPRESSED AIR FROM THIS UNIT MAY CONTAIN CARBON MONOXIDE.
The air produced is neither suitable for breathing nor food processing without
fi ltering and testing to all applicable legal standards.
2. AIR ONLY: Use this compressor for compressing air only. Do not compress
other gases.
3. BREATHING PROTECTION: Always use a respirator when spraying paint or
chemicals.
4. MAINTAIN TOOLS WITH CARE. Keep tools clean for better and safer perform-
ance. Follow instructions for lubricating and changing accessories. Keep dry,
clean and free from oil and grease.
5. NEVER USE THIS EQUIPMENT if it is leaking air; has missing or damaged
!
parts, guards, or shields; or requires repair. Make sure all screws and caps are
securely tightened.
6. DO NOT USE THE AIR HOSE to move the compressor. Release the pressure
in the storage tank before moving.
7. DO NOT ATTEMPT ANY MAINTENANCE OR ADJUSTMENT with the compres-
sor in operation, the power connected, or air under pressure in the system.
8. CHECK FOR DAMAGED PARTS. Make frequent inspections for the correct
function of components and safety mechanism.
9. REPLACEMENT PARTS. When servicing, use only identical Superior replace-
ment parts and fasteners recommended by us.
10. EMPLOYERS must enforce compliance with the safety warnings and all other
instructions in this manual. Keep it available for use by everyone assigned to
use this equipment.
SAFETY PRECAUTIONS SPECIFIC TO COMPRESSOR COMPONENTS SAFETY PRECAUTIONS SPECIFIC TO COMPRESSOR COMPONENTS
1. TANK SAFETY VALVE: This valve prevents damage to the air receiver if a mal-
function in the compressor pump occurs. It is factory pre-set at a limit specifi c to
your particular model and adjustment. Do not tamper with it. This will automati-
cally void your warranty.
2. PRESSURE SWITCH: The air pressure switch is factory pre-set for optimum per-
formance. Do not bypass or remove this switch. Serious damage to equipment or
personal injury could result from too high an air pressure.
3. MOTOR AND COMPRESSOR PUMP: Air compressors get hot during operation.
Do not touch the motor, discharge tubing, or compressor while it is running. The
!
compressor turns itself on automatically while the power is connected.
4. AIR TANK: Over-pressurizing the air receiver, piping or tank could cause it to
explode or burst. To protect from over-pressurizing, the compressor is equipped
with a factory preset safety valve. Do not remove, make adjustments to or sub-
stitutions for this valve. Perform a test of the valve from time to time: pull the ring
on the valve to make sure that it operates freely. If the valve does not operate
freely, replace it before further use. Never weld to, drill into, or change the air
receiver in any way.
5. TAMPERING: If any of the components above are found to have been changed
or tampered with, the warranty will be made void. When servicing, we recom-
mend using only identical Superior replacement parts and any replacement parts
used must have the same specifi cation as the original equipment.