Setup & Operation - Concept CAC150RK Manuel De L'utilisateur

SPECIFICATIONS SPECIFICATIONS
 Mini Flash Light
 Includes: 20' x 1/4' Recoil Hose, quick-connect air fi tting, air gun, air connection
nipple, tire chuck, tapered infl ation nozzle, 2 ball infl ation needles, hex key and
fuse.
 Tool weight: 20.9 lb / 9.5kg
A tool with a higher air demand than this compressor can produce may either not
function, or not function well. It may also cause the compressor to run without
stopping for long periods of time, trying to maintain pressure in the tank. This can
cause either the motor or compressor pump to overheat and damage them. Be sure
the requirements of your tools can be met by the compressor.
To compress air, the piston in the pump moves up and down in the cylinder. On
the down stroke, air is drawn in through the inlet valve. Since the discharge valve
remains closed, as the piston goes up, the air in the cylinder is compressed. The inlet
valve closes and compressed air is forced out into the air receiver. A check valve
prevents it from going back into the pump. Working air is not immediately available.
The pump continues to add air until the air receiver pressure builds to above that
required at the regulator.
2" BRAD NAILER
 Shoots industry standard 18 gauge brad nails in the following sizes: 15mm
(5/8"), 20mm (3/4"), 25mm (1"), 30mm (1-3/16"), 35mm (1-3/8"), 40mm (1-
9/16"), 45mm (1-3/4"), and 50mm (2").
 These brads are perfect for installing trim and mouldings, for cabinet and furniture These brads are perfect for installing trim and mouldings, for cabinet and furniture
making, and for picture framing and for applications where gluing is necessary,
but clamping is impractical.
 Air consumption is 2 – 4 cfm / 57-113 litres per min.i@414-621 kPa / 60 to 90 psi. Air consumption is 2 – 4 cfm / 57-113 litres per min.i@414-621 kPa / 60 to 90 psi.
 Quick-release nose piece.
 Padded hand grip.
 Adjustable exhaust defl ector
 Air inlet: ¼"NPT
 Included:
 S3 hex key
 S4 hex key
 Small bottle of air tool oil
 Tool weight: 3.3 lb / 1.5 kg
SETUP & OPERATION SETUP & OPERATION SETUP & OPERATION
! REMEMBER: After unpacking this unit, inspect carefully for any damage that may
have occurred during transit. Make sure to tighten fi ttings, bolts, etc, before putting
into service.
 Locate the compressor in a clean, dry and well-ventilated area, on a fi rm level
surface.
 It should be located 30 to 45cm / 12 to 18 inches from a wall or any other ob-
struction that would interfere with the air fl ow. It is equiped with heat dissipation
fi ns that allow for proper cooling. Keep them and other parts free of dust or dirt
that could interfere with cooling. A clean compressor runs cooler and provides
longer service.
 Do not place anything on top of the compressor.
!
 Do not use lead-tin solder to join pipes and fi ttings. It can melt at the
temperatures of the compressor's air discharge and cause the piping to burst.