Yamaha SRT-1000 Mode D'emploi page 17

6
Teach the unit the "Volume (+)" code of the TV's remote control.
6-1 Press VOLUME (+) on the front panel of the unit.
6-2 While pointing your TV's remote control at the remote control sensor, hold
down the volume (+) key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 6-1.
7
Teach the unit the "Power" code of the TV's remote control.
7-1 Press (power) on the front panel of the unit.
7-2 While pointing your TV's remote control at the remote control sensor, hold
down the power key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 7-1.
8
To finish the learning mode, press the LEARN key on the unit's
remote control.
This completes the necessary settings. Now you can operate the unit with the TV's
remote control's mute key, volume keys, or power key.
HINT
• The learning mode will be finished automatically if no operations are performed for 5 minutes.
• Set the TV volume to minimum. When you turn up the volume of the unit with the TV's remote
control, the volume of the TV may be turned up at the same time. In this case, follow Step 4 in
"Connections" (p.5) to change the TV setting.
• You can press the (power) key on the unit's remote control to finish learning mode.
Lights up
Flash
Lights up
Flash
Clearing all learned operations
1
With the unit turned off, hold down the LEARN key on the supplied
remote control for more than 3 seconds (for entering the learning
mode).
When the unit is in the learning mode, the indicators on the front panel flash as
shown below.
2
Hold down INPUT on the front panel of the unit for more than 3
seconds.
If the clearing is completed, you will hear the bleep sound three times.
3
Press the LEARN key on the supplied remote control.
Flashes in red (cleared)
15