Assembly And Installation; Electric Connection; Start-Up - Aqualytic AL40 Mode D'emploi

Assembly and installation

GB

Electric connection

After unpacking the instrument, place the unit on a laboratory bench .
Before connecting the instrument to the electric line, make sure that the values on the rating
plate correspond to those of the electric line .
Use the supplied external power to connect the instrument to the socket .
The supplied external power allow to connect the instrument to net power lines between
100 and 240 Volt with 50 or 60 Hz .

Start-up

After connecting the instrument to the electric line, place the sample containing beakers
on the instrument, with the stirring rod facing inside .
Do not turn the instrument on before positioning the beakers (thus protecting the blades) .
In order to place the beakers it is necessary to pull stirring rods up, just sufficiently, by
holding them by the suitable black pommels; to place the beakers (one for each stirring
rod) and to pull down the rods .
Ensure that the power switch is turned to "0" (OFF) before removing the beakers contai-
ning the stirring liquid .
Select the the desidered modality of running (continuous, with minutes base and with
hours base) by the keys of the electronic power window on the control pannel .
Select the desired speed by the keys of stirrer speed window .
21
Floc-Tester_AL40_AL50_5 04/2014