Operating Controls; Speed Setting - Aqualytic AL40 Mode D'emploi

Operating controls

GB
The start-up is empowered by the keys ↑ and ↓ . t's possible to select the speed from
0 to 300 rpm by the speed arrow keys . The display shows the selected speed of the stirring
rods . The progression speed is increased by keeping one of the two keys pushed, in order
to reach the desired value faster .
Electronic timer setting
It's possible to select three different type of running by the Set key on the "Electronic Timer
Window":
Continuous
With timer (minutes base)
With timer (hours base)
It's possible to select the desired modality just by pressing the Set key and the display will
show as follows:
Continuous way:
With timer (minutes):
With timer (hours):
In order to change the timer modality maintain the Set key pushed for a few seconds . To
set the desired time use the keys ↑ and ↓ .
The display shows the count down and simultaneously the third decimal point turns on to
indicate that the count is operative . At the end of time the instrument stops the stirring,
the acoustic signal warns the end of the time and the display shows "End" .

Speed setting

By the arrows key on the "Speed" window it's possible to select the desired speed from 10
to 300 rpm with 1 rpm resolution . Maintaining pressed one arrow, increase the progression
speed in order to reach more quickly the desired value .
The speed is not active if the time is not selected
22
"... . ."
"000"
"h00"
Floc-Tester_AL40_AL50_5 04/2014