Assembly And Installation; Electric Connection; Start-Up - Aqualytic AL30 Mode D'emploi

Assembly and installation

GB

Electric connection

After unpacking the instrument, place the unit on a laboratory bench .
Before connecting the instrument to the electric line, make sure that the values on the rating
plate correspond to those of the electric line .
Use the external power supply to connect the instrument to the socket .
The power supply can be from 100 to 240V AC with a frequency of 50 or 60Hz .

Start-up

After the connection of the instrument to the electric feeding place the beckers with sam-
ple on the instrument with inside the stirring shaft .
Pull to the top the stirring shaft by the black plastic knob in order to insert the beckers in
each position and then take them down .
Do not turn the instrument on before positioning the beakers (thus protecting the blades) .
Ensure that the power switch is turned to "0" (OFF) before removing the beakers contai-
ning the stirring liquid .
17
Floc-Tester_AL30_4 07/2014