WIKA TFT35 Mode D'emploi page 8

3. Safety
The integrated thermowell with fixed threaded connection or adjustable
compression fitting enables direct installation into the process. All wetted
parts and also the case are from stainless steel.
EN
The case and the exchangeable measuring insert are screwed together
using a knurled nut. This enables the exchange of the measuring insert
without having to remove the instrument from the process.
Through the integrated coupler connector, simple installation of the
transmitter is ensured.
The integrated electronics convert the temperature-dependent
resistance signal of the measuring element into a linear unit signal. For
the signal outputs, 4 ... 20 mA, 0 ... 10 V and also 0.5 ... 4.5 V ratiometric
are available.
This instrument is not permitted to be used in hazardous areas!
The instrument has been designed and built solely for the intended use
described here, and may only be used accordingly.
The technical specifications contained in these operating instructions
must be observed. Improper handling or operation of the instrument
outside of its technical specifications requires the instrument to be taken
out of service immediately and inspected by an authorised WIKA service
engineer.
The manufacturer shall not be liable for claims of any type based on
operation contrary to the intended use.
8 WIKA operating instructions model TFT35