Remote Control; Address Settings - VOLTCRAFT SWD Série Notice D'emploi

DVD player
SAT receiver
LCD screen 20"
Tube TV 55cm tube
a notebook
Coffee machine
Hairdryer
Vacuum cleaner

Remote Control

All SWD series models are equipped with a remote control function. There are three optional remote controls.
They are connected to the converter by special sockets. Operation and connection is explained in the opera-
ting instructions of the respective remote control. The following remote control are available:
FB-01 SWD Switch remote control
Simple cable-bound remove control that can be switched on and off and with indicator lamps for input
and output.
FB-02 SWD LCD remote control
Cable-bound remote control that displays date and time, input and output voltage and the current output
power. This remote control can also be used to customize the deep discharge protection. Furthermore, a
SD card slot is available. Here, operating data can be stored on optional SD memory cards and evalua-
ted on the computer. Voltage is supply through the converter.
FB-03 SWD LCD remote control
Wireless remote control with radio transmission. Equipment and operation corresponds to FB-02 SWD.
The wireless remote control is supplied by a battery.

Address Settings

Address settings enable control and data readout for up to 4 converters with one LCD remote control. The
converter is assigned an address from 1 to 4 by changing the DIP switch position (switch pair 3 and 4).
The default address is "4".
When an LCD remote control is connected to only one converter, no address needs to be
set with the DIP switch (4) pair 3 and 4. This setting is only needed for several converters
with a single remote control.
To set the desired device address, select the respective switch combination with the switch pair 3 and 4
at the DIP switch. Use a pointed object for setting.
32
approx. 30 W
approx. 40 W
approx. 75 W
approx. 80 W
approx. 70-150 W
approx. 1300 W
approx. 1500 W
approx. 1500 W