Start-Up; Standby Operation - VOLTCRAFT SWD Série Notice D'emploi

Start-up

Do not operate any devices connected to the converter while driving.
After connection to the battery, you may commission the DC-AC converter.
Connect a consumer with suitable rated output to the output socket (13).
Switch on the converter with the operating switch (11). Switch position "1" (On) If the connection is cor-
rect, the two displays (9) and (10) light up now and indicate correct operation.
LED indicator lamps
The green LED indicator lamps 9 (DC input) and 10 (AC output) supply important information about the
converter's operating state. The two LEDs are working independently of each other. This means that any
interference in the DC input area directly influences the function of the AC output and that an interference
of the output area directly influences the input function.
Operating mode/interference displays
Device is switched on and ready for operation.
Preliminary warning for deep discharge
protection
Switch-off due to deep discharge protection
Overvoltage at input
Short circuit or overload at the output

Standby Operation

In StandBy operation, the converter was switched off and verifies that a load > 10 watt is present at the
output at intervals of approx. 20 s. This reduces internal power consumption and relieves the connected
DC power source.
If a load >10 watt is recognised, the output switches to normal operation. When the consumer was swit-
ched off, the converter automatically goes back to StandBy mode.
To activate this mode, put the small switch no. 2 to "ON" at the DIP switch (4). The
switch points downwards.
To switch off this function, put the small switch no. 2 upwards. The converter is in
continuous operation again.
LED 9 (DC input)
Is lit
Flashing slowly
Flashing quickly
Flashing quickly
Flashing quickly
LED 10 (AC output)
Is lit
Is lit
Flashing quickly
Flashing quickly
Flashing quickly
29