Put dishes, cups, glasses, forks, knives and spoons in their respective baskets. (B)
Place the dishes in the relating basket with supports making sure that the dishes face
upwards. Place knives and spoons with their handles facing down. We recommend
washing glasses before or with renewed tank water. In order to save on detergent and
electricity we recommend beginning the washing with full basket avoiding over loading
them. We recommend respect space between the dishes. We recommend pre-cleaning
of the dishes to minimise the maintenance. In order to obtain the best result of washing
we recommend rinsing roughly the dishes and to remove parts of paper, lemon, olive,
core etc...in order to avoid them to obstruct the filter of the tank and so reduce the
quality of the washing.
It's the same for the dried food particles; we recommend pre-cleaning the dishes before
cycling.
2. Cleaning and care
Routine maintenance
YOU MUST clean the inside of the machine at least twice a day, or better yet, whenever
you notice the presence of waste in the tank filter. Remove the filters from the tank if
present, (C-10) for cleaning. Drain the water of the tank by lifting the overflow drain (C-
2). Remove the filter pump (C-4) in order to clean it. Clean the tank by removing all
residues and all solid waste that might be there. Ensure that the rotating spray arms for
washing are able to rotate. Using a cutting-edge, clean nozzles hole to avoid they were
clogged with solids. Replace all the elements by performing the opposite way. Leave
the door opened when the appliance is not used. To avoid the risk of oxidation or
chemical attack of any kind, keep the surfaces of the steel appliance always clean.
NEVER USE YOUR APPLIANCE WITHOUR THE PUMP PROTECTION FILTER.
Periodic maintenance (every 2-3 days)
Important: your appliance cannot be clean by water jet (neither water jet under
pressure). Water could enter electric parts and leads to damages that cannot be
considered under warranty.
•
Completely drain the machine following the procedure described above.
•
Stop the machine by pressing the line button (A-1) ("0").
•
Turn off the power using the power switch located upstream of the device.
•
Clean the filter tank (C-4) and the filter pump (C-1).
•
Remove the rotating spray arm flushing upper and lower (C-7) by loosening
the central fastening ring.
•
Check and clean all nozzles.
•
Remove the rotating spray arm wash upper and lower (C-6), by removing the
axes of rotation.
•
Check and clean all nozzles.
•
Clean the tank thoroughly.
•
Replace all the elements by performing the opposite way.
•
Leave the door of the appliance opened when not in use.
35