Publicité
Les langues disponibles
Les langues disponibles
Manual draining
Regenerating cycle
Washing cycle
Appliance off(pause)
Regenerating alarm
Thermometer alarm (optional)
If temperature probe is disconnected or cut off the display A-3 A-4 will show:
If temperature probe is in short circuit or temperature over to 107°C A-3 A- will show:
Checking
Before using your appliance check the following points.
1)
Level of water and its temperature.
2)
Level of detergent.
3)
Level or rinsing product.
4)
Temperature of the feeding water.
5)
The washing products : fill the tubes and clean the holes of the tank
The water is dispended at high pressure throughout the sprayers. The washing and
rising arms must be free to rotate without any obstacle.
During every washing cycle the dispensers must diffuse the right quantity of washing
and rinsing product. Check the liquid levels and if necessary fill them up. The pump filter
must be clean.
At the end of the cycle the dishes must dry quite instantly by evaporation when you
remove the basket from the appliance.
Each time the appliance is turned off with the button A-1, it will start again from the last
selected washing cycle when activated as well as when program with automatic stop
like regenerating one are initiated.
The continuous washing cycle is never started automatically when the appliance is
turned on. When the appliance is off by cutting off the main power selector on the wall
then the appliance will start from the normal washing cycle when the selector will be on
the on position. The program can be selected only when the appliance is off. During all
cycle the button A-3 is off.
Instructions for washing.
Never immerse your hands in the washing water. If it occurs immediately rinse your
hands with cold water.
Blinking 1 sec
On
Blinking 1 sec
Blinking 1 sec
Blinking 1 sec
34
Publicité
Chapitres
