Casselin CLVD Mode D'emploi page 30

Washing programs
The dishes washer offers various programs which can be selected from the control
panel.
Duration of programs:
Short (if included) for a small amount of items with a limited amount of non-greasy
residue.1 min
Normal for normally dirty 2 min
Long for very dirty 3 min
Intensive (if included) for pans or kitchen tools Max. 8 min
Regenerating program (if water softener is present) to regenerate the resins in the
water softener 21 min
Tank draining (if equipped with drain pump): to drain the water off 2 min 20 sec
Function
After having switched the mains power on (on the wall) the Led (A5) lights on to show
that the appliance is connected. By pressing the ON/OFF button (A1) for at least 3s the
appliance starts filling the tank and the boiler. The heating begins when the correct level
of water is reached. Once the good temperatures are reached the thermometers (if
fitted) and the light (A6) light on. Wait for a few minutes to control that the temperatures
quoted on the control board (if option fitted)(A7 and A8) are ok : 85°C for the boiler and
60°C for the tank. If thermometers are not fitted your appliance is equipped with a Led
that lights up when the goods temperatures are reached.(A9). Then you can press the
button A3 to activate the washing cycle. The start of the program is not in relation with
the tank or boiler temperature. The appliance works with automatic washing program:
washing, water dripping pause, rinsing. The quantity of rinse aid liquid is regulated by
the dispenser unit inside the appliance filled up through the external bin. The quantity of
detergent is either regulated handily or by external or internal dispenser.
• Washing
The pump brings the washing water from the tank to the dishes through the pipe system
and the upper and lower washing arms. During the washing operations the washing
water goes through a filter system: all solid residues are blocked and so the pump
impeller is protected.
After washing operations the appliance stops for a few minute to evacuate washing
water.
• Rinsing
Then the dishes are rinsed with hot clean water from the boiler to remove all residues of
the washing water. The rinsing water heats the dishes in order to allow them to dry
quickly once out of the appliance and to regenerate the washing solution in the tank.
.
30