Cleaning And Care - Casselin CLV35 Mode D'emploi

5. CLEANING AND CARE

Routine maintenance
The appliance must be cleaned inside at least twice a day or whenever there are solid particles
in the wash pump filter C4. Drain the water by un plugin the over flow C2. For appliance
equipped with drain pump, remove the overflow, press A3 until the tank is completely empty,
push main button A1 on O position. When the machine is completely empty, remove filters and
clean them. Clean the tank and remove any small residues and solid particles. Make sure that
the rotary wash arms C6 are free to rotate. If the nozzle holes are clogged by solid particles,
remove them carefully with a fine tipped tool. Leave the appliance door open for the entire
period. To avoid oxidation or chemical attack hazards in general, the steel surfaces must be
kept thoroughly cleaned.
NEVER USE THE APPLIANCE WITHOUT THE PUMP PROTECTION FILTER.
Periodic maintenance (every 2-3 days)
NOTICE: no direct washing via water jets. Neither jet under pressure
In order to avoid any possibility of water invasion that can invalidate the good running of the
appliance and the security for use and the warranty it is recommended:

Drain the water completely from the appliance as described below

Turn the appliance off by pushing the button (A-1) (position "0").

Turn off the electric power supply by disconnecting the main switch installed
upstream from the appliance.

Remove the pump filter and drain filter and clean them.

Dismantle the upper and lower rinsing arms by removing them from the rotary pivots.

Check and clean them.

Dismantle the upper and lower washing arms by removing them from the rotary
pivots.

Check and clean them.

Thoroughly clean the tank.

Replace all the parts that were removed proceeding in the reverse order.

Let the door opened when the appliance is not in use for a long period.

Clean external surfaces with soap and water. Rinse and dry them with care.

NOTICE: Never clean it with steel shavings, wool or brushes.
Lime deposits and scale will build up on the inner surfaces of the boiler tank, the pipelines and
tank due to calcium and magnesium salts present in the water. These scales and deposits can
prejudice proper appliance operation. The appliance must be periodically descaled and we
recommend that this operation been done by a qualified technician.
If the machine fails to operate correctly or breaks down, disconnect it from the electricity mains
and call a qualified service center
Version 270114
23