Instructions For The Fitter - Hotpoint Ariston AWM 1081 Mode D'emploi

Instructions for the fitter

GB
Mounting the wooden panel onto the
door and inserting the machine into
cabinets:
In the case where the machine must be ship-
ped for final installation after the wooden panel
has been mounted, we suggest leaving it in its
original packaging. The packaging was desig-
ned to make it possible to mount the wooden
panel onto the machine without removing it
completely (see figures below).
The wooden panel that covers the face of
the machine must not be less than 18 mm
in thickness and can be hinged on either the
right or left. For the sake of practicality when
using the machine, we recommend that the
panel be hinged on the same side as the door
for the machine itself - the left.
A
C
te
Tur sei
E
18
Door Mounting Accessories (Fig. 1-2-3-4-5).
N° 2 Hinge Supports
Fig. 1
Fig. 3
B
N° 1 Rubber plug
Fig. 5
- No. 6 type A self-threading screws, l =13 mm.
- No. 2 type B metric, countersunk screws,
l =25; for fastening the magnet plate to the
cabinet.
- No. 4 type C metric screws, l =15 mm; for
mounting the hinge supports to the cabinet.
- No. 4 type D metric screws, l =7 mm; for
mounting the hinges on the supports.
D
Mounting the Parts onto the Face of the
Machine.
- Fit the hinge supports to the appliance front
panel, positioning the hole marked with an ar-
row in fig. 1 so that it is on the inner side of the
front panel. Fit a spacer (fig. 4/B) between the
surfaces using type C screws.
- Fit the magnet plate at the top of the op-
posite side, using type B screws to fix two
spacers (fig. 4/B) between the plate and the
surface.
N° 2 Hinges
Fig. 2
N° 1 Magnet N° 1 Magnet plate
Fig. 4
N° 4 Spacers
Fig. 4/B