Domo DO7052S Mode D'emploi page 51

www.domo-elektro.be
temperature regulator to the MAX position. The indicator light will show that the
device is heating up. When the iron is at temperature, the light will turn off.
• Hold the iron between 15 and 30 centimetres from the fabric.
• Press on the steam boost button. The steam will penetrate the fabric and remove
the wrinkles. Wait a few seconds before using the steam boost button again.
Automatic Shut-Off
The device will stop heating automatically when the iron has been horizontal
(unmoved) for approximately 30 seconds. When you move the device again, it will
begin to heat up.
In a vertical position, this will take about 8 minutes.
CLEANING
Self-cleaning
This function removes the lime scale and minerals that build up in the steam chamber.
This treatment is best done once a month to keep the iron in optimal working
condition. Depending on the hardness of the water, this treatment may have to be done
more than once a month.
1. Fill the iron as described in "Filling the water reservoir". Fill the water tank
halfway.
2. Place the iron straight up on a flat surface.
3. Put the plug in the mains.
4. Put the device on at the max. temperature. Wait until the device is at temperature.
5. Turn the device off.
6. Remove the plug from the outlet.
7. Hold the iron horizontally above the sink.
8. Press the self-cleaning button and hold it down.
9. Steam and boiling water will come out of the holes in the sole of the iron, rinsing
the lime scale and minerals out.
10. Move the iron gently back and forth, until the water tank is empty.
11. Release the self-cleaning button when you are finished cleaning.
12. Place the iron in a vertical position and allow it to cool completely
13. Dry the sole with a cold, damp cloth.
Note: Make sure you do not come into contact with the hot water.
Cleaning the iron
Clean the sole of the iron with a damp, clean cloth. Do not use any sharp object or
aggressive cleaning products.
51
DO7052S