Instructions For Use; Adjusting The Auxiliary Handle - Flex CHE 2-28 R SDS-plus Notice D'instruction D'origine

Instructions for use

Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or
damaged.

Adjusting the auxiliary handle

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Use electric power tool with attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
 Loosen the clamping by turning the
clamping screw anti-clockwise.
 Swivel the auxiliary handle into the
required position.
 By turning the clamping screw clockwise,
fix the handle in the required position.
16
Attaching the depth stop
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
 Press and hold clamping lever on the
auxiliary handle in the upper area.
 Push in depth stop.
 Set depth stop to the required drilling
depth.
 Release clamping lever.
Inserting tools with SDS shank
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Used insertion tools may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS shank.
If tools do not have an SDS shank
(e.g. wood drill bit), a three-jaw chuck
must be used.
 Check dust cap.
– Clean dirty cap.
– Have a defective dust cap replaced.
CHE 2-28 R SDS-plus