Burda io TERM2000 IP67 Mode D'emploi page 13

GB
GB
3.6. Press the button UP and DOWN simultaneously until the lamp is ON/OFF in one cycle.
3.7. Briefly press the PROG button: the lamp is ON/OFF one time, to indicate that the remote control
had been matched with the heater.
4. USE
4.1. Press "Select" BUTTON to change the channel. The factory default set channel 1 for heaters. Totally 5
channels are available for selection.
4.2. Press UP button, the heater starts to work at high power setting
Press DOWN button, the heater is power off
4.3 Move the thumbwheel up or down, vary the heating from LOW-MED-HIGH, or from HIGH-MED-
LOW.
LOW
HIGH
MED
5. Set My favorite power level
5.1. Select the channel for the heater, select the favorite power level (LOW, MED or HIGH), and then
press "MY "button for approx. 5 seconds. The lamp will be ON/OFF in one cycle, my favorite power level
has been set to the MY button.
5.2. Select the channel for the heater, set it in the favorite power level, and then press the button
"MY"(approx. 5 seconds) to remove my favorite power setting.
5.3. Briefly press MY button when the heater is in standby or other power level, the heater will start to
work or set to the favorite power level.