Technical Data; Troubleshooting - Heylo 1 101 909 Manuel D'utilisation

4. Technical Data

Total output
Heat output (level 1 / level 2)
Motor output
Control possibility
Electric Connection
Electricity (ventilate / level 1 / level 2)
Air volume
Increase in temperature
Weight

5. Troubleshooting

ERROR
Appliance does not start
up
Appliance heats up, fan
does not run
If the appliance is supplied with electricity by the mains cable, work to the
electrical system can only be carried out by specialist electrical staff or a person
trained in electrical appliances in accordance with VBG 4.
Please only get repair work to the electrical appliance done by HEYLO service partners.
Discontinuing use and disposal of the appliance
The appliance has been designed for long term use.
If it has to be disposed of, please do so in accordance with the current relevant laws in an
environment friendly manner.
CAUSE
1. Main switch switched off
2. Indoor fuses tripped.
3. Internal fuse (13A) has been
activated.
4. Plug has been pulled out of the
main switch panel or extension
cable.
5. Supply line defective.
6. Mains switched off
7. Safety temperature limiter tripped
8. Indoor residual-current-circuit
breaker trips.
9. Heating coil defective.
10. Fan defective
11
W 2.020
W 1.000 / 2.000
W 20
° C 5 - 40
V/Hz 230/50
A 0,13 / 4,4 / 8,8
m³ / h 90
K 62
kg 2,5
SOLUTION
Check up to what point electricity is
available. Repair defect.
Wait until electricity returns. Check
safeguards.
Appliance was overheated. Repair
source of error and the appliance
will switch itself on again after
waiting for a while.
Clean heating coil (possibly with
compressed air) otherwise send it
to be repaired.
Appliance could have come into
contact with moisture. If yes, let it
dry thoroughly before operating it.
Send appliance to be repaired
Send appliance to be repaired
EN