Use - Life & Mobility ROLLIT Mode D'emploi

Inspired by life

Use

Removing and fitting the headrest*
The headrest can be removed easily:
1. Unscrew the star grip until loose.
2. Remove the headrest.
Putting it back in place:
3. Place the headrest in the holder.
4. Screw fast the star grip.
* If present
Making transfers
The Rollit is a wheelchair for users with various limi-
tations. Transfers from the wheelchair to the bed,
toilet or shower, and so on, and vice versa, can be
carried out in different ways.
The lifting method depends on the degree to
which the wheelchair user can cooperate. The
wheelchair enables both active and passive trans-
fers with or without the help of an assistant or a lift.
Attention:
n Always set the brake on the wheelchair before
making a transfer.
Transfer from the front
1. Fold up the foot plates. Or, if necessary, swing
out the foot rests.
2. Engage the wheelchair brake.
Transfer from the side
If necessary, fold the sides fitted with arm rests up
and backwards.
EN16
Steps
Headrest
Slope
Negotiating obstacles with an attendant
1. Push the step tube down with your foot and push
the handles down with your hands.
2. Push the wheelchair onto the elevation (obstacle)
and take your foot off the step tube.
3. Push the wheelchair further and lift the rear wheels
over the obstacle with the push handles.
Go up steps forward and down steps backward.
Attention:
n Keep speed under control when going down a
gentle slope.
Brakes
The wheelchair brakes are adjusted to the proper set-
ting at the factory as standard. Life & Mobility recom-
mends that you always use both brakes when getting
in or out of the wheelchair.
Use
EN17