Figure 3-7 Sensor; Figure 3-8 Sensor Installation - Siemens SITRANS FUP101 Mode D'emploi

Commissioning
3.4 Sensor Installation
10. Take either sensor and apply a continuous lengthwise 3mm (1/8-inch) bead of coupling
28
compound across the center of the sensor emitting surface.
①
F-Connector
②
Angled Edge
③
Sensor
Figure 3-7 Sensor
①
Front View
②
Spring Clip (Not present on some
models)
③
Sensor Clamping Screw
④
Spacer Bar
⑤
1012 Series Mounting Frame
Figure 3-8 Sensor Installation
④
Front Face
⑤
Emitting Surface
⑥
Coupling Compound
⑥
Mounting Strap
⑦
Note: Operational 2nd Mounting Strap
shown. Larger pipes over 76cm (30 inches)
may need an additional support.
⑧
Spacer Bar Platform and Clamping Screw
⑨
Spacer Bar Reference Hole
⑩
Orientation for Single Beam Sensor at 9
o'clock position
⑪
Orientation for Dual Beam Sensor at 10 & 2
o'clock positions
Operating Instructions, 01/2013, CQO:QSG003 Revision 05
FUP1010 IP67 Portable Quick Start