Setting The Parameters - Siemens SITRANS FUP101 Mode D'emploi

3.3

Setting the Parameters

Select Language and Units
Note
Before creating a site select a language and then English or Metric units from the Meter
Facilities menu.
Select a Meter Type
1. Press the <MENU> key and select the Meter Type.
2. Press the Right Arrow> and scroll to [2 Channel Flow]
3. Press <ENTER> to select. Press <Right Arrow> to select meter function. Press
Create a Site
1. Before proceeding make sure that English or Metric units have been selected.
2. At the [Channel Setup] Menu press <Right Arrow> and enter a Site name.
3. Press <ENTER> to create Site name (e.g., ABC). (See figure below.)
FUP1010 IP67 Portable Quick Start
Operating Instructions, 01/2013, CQO:QSG003 Revision 05
Note
Select [2 Channel Flow] if measuring two different pipes and [2 Path Flow] if sensors are
mounted on the same pipe.
<ENTER>.
①
Select for measuring two different pipes. (Not available for all models.)
②
Select if two sensors are mounted on the same pipe.
③
Select for summing or subtracting flow from two different pipes.
Commissioning
3.3 Setting the Parameters
17