Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection
Ignition key
switch
Car fuse box
Car fuse box
(Main fuse)
C
Battery
Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
Connect to vehicle's reverse lamp harness when
Connect to the terminal that is grounded when either
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
|
4
DNX8120/DDX812/DDX8032BT
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
B
A
B
C
PRK SW
For the sake of safety, be sure to connect the parking sensor.
using the optional rear view camera.
To steering remote
To car light control switch
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) -
(To car chassis)
Reveres sensor wire (Purple/White)
Steering remote control input (Light Blue/Yellow)
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Dimmer control wire (Orange/White)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
FM/AM
Antenna Cord
antenna input
Publicité
Table des Matières
