Astralpool OPTIMA PLUS Manuel D'installation page 9

Paragraph 5 – Setting the Maximum Flow
Programming
PROG
Pump Functions
-
Max flow rate
Max flow rate
P100%
P100%
-
Max flow rate
F320s/m
Paragraph 6 – Setting the Alarm Relay
Programming
PROG
Pump Functions
-
Max flow rate
P100% -
Alarm Relay
N.Open
-
Paragraph 7 – Power On Delay Setting
Programming
EM00136408
-
+
-
-
+
-
-
+
-
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when
displaying the flow. Changes can be made by pressing the
key, then using the
value. Press to confirm and return to the main menu
In the absence of an alarm situation, it can be set as open
(default) or closed.
Changes can be made by pressing the
using the
to confirm and return to the main menu
Allows the user to set a pump activation delay time when turning on
the pump itself. This delay will only take effect if the pump is turned
off and then on again by disconnecting its electrical power supply.
The setting can be disabled (Off - factory default) or else can be set
to a delay time ranging from 1 to 60 minutes.
The alarm and pulse LED indicators will flash while the delay time
is in progress (1 sec ON - 1 sec Off) and the countdown will be
shown on the display in seconds. If the pump is in Stop mode, the
LEDs alone will be flashing. While the time delay is in progress, the
function can be disabled by accessing the menu and setting the
time to Off.
Press to access the modification option and use the
buttons to set the desired value. Press
return to the main menu.
rev. 1.0
Operation
keys to set the new
Operation
keys to set the new value. Press
Operation
key, then
and
to confirm and
7