Programming Additional Transmitters; Deleting Transmitters - Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation

Programming additional transmitters

In addition to the master transmitter, up to 15 further trans-
mitters can be programmed in the radio receiver.
Press the programming button of the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The sun protection shifts to confirm.
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The sun protection shifts to confirm.
► The new transmitter has now been programmed.
Deleting individual transmitters
Press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Now press the programming button of the transmitter to be deleted for 3
seconds.
▻ The sun protection shifts to confirm.
Then re-press the programming button of the transmitter to be deleted for 10
seconds.
▻ The sun protection shifts to confirm.
► The transmitter is now deleted from the radio receiver.
30 - en

Deleting transmitters