To Stop The Product; To Operate The Product - Husqvarna 350BT Manuel D'utilisation

8. If the engine is cold, push the choke lever to the
open choke position gradually until the choke lever
stops.
9. If the engine is cold, let the engine operate for 2-3
minutes to become warm before operation.
WARNING:
the engine is started and when the
product is set at idle speed. Do not let
persons to come near the product or the
blower tube.
To operate the throttle control/stop
switch
B
C
D
• Apply full throttle (A).
• Apply 1/3 speed (B).
• Apply idle speed (C).
• Stop the product (D).

To operate the product

• This blower is a backpack type, and is carried using
a shoulder harness while operating. It is operated
and controlled with the handle on the tube using the
right hand.
• Operate the product at usual work hours. Obey local
regulations.
1246 - 004 - 18.10.2021
Air is released when
A
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note:
Husqvarna recommends that you use the
full blower nozzle extension.
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.

To stop the product

CAUTION:
full speed.
1. Put the start/stop switch with throttle control in the
stop position. Refer to
stop switch on page 9 .
To adjust the harness
1. Put on the harness of the product.
2. Tighten the shoulder straps until the product is tight
against your body.
3. Put the waist belt around your waist.
Do not stop the product at
To operate the throttle control/
9