Cata TFH 6630 X Manuel D'utilisation page 12

EN
Problem
Excessive vibration.
The light is on, but the fan
does not work.
Both the light and
motor do not work.
Suction performance
reduced.
Works normally but
cooking smells linger.
The hood does not
work
The hood still does
not work
12
Possible cause
The appliance is not installed
properly on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters
are dirty.
Top vent might be
obstructed.
Optional vent kit might be twisted.
The installation may not comply with the
manufacturers instructions.
Carbon filter is not fitted in
recirculation mode or is full of
grease.
Check that the hood is connected to power. Check that the fuses or automatic have
not jumped.
If, after having checked the points mentioned above, your problem has not yet
been solved, contact the technical service or your distributor.
Solution
Take down the appliance and check
it is properly fixed.
Switch off the appliance. Repair to be
carried out by qualified service
personnel only.
Contact Customer Services on.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See Care
and maintenance section).
Clear any obstruction.
Ensure that the vent kit
is fitted according to the
manufacturer's instructions.
The vent hose should be correct
diameter throughout with no reductions
or restriction.(See installation section).
Fit carbon filter or replace the
carbon filter (See Care and
maintenance section).
FAQS