Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Driving and removing of small screws, small bolts, etc.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Rechargeable
battery
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Battery
Fig. 4
12
Latch
Insert
Pull out
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Pilot Lamp
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
you or someone around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have it
repaired immediately.
Publicité
Table des Matières
