Hitachi P 20SB Mode D'emploi Et Instructions De Securite page 16

English
4. Inspecting the carbon brushes (Fig. 20)
The motor employs carbon brushes which are
consumable parts. Replace the carbon brush with
a new one when it becomes worn to its wear limit.
Always keep carbon brushes clean and ensure that
they slide freely within the brush holders.
CAUTION: Using this planer with a carbon brush
which is worn in excess of the wear
limit will damage the motor.
NOTE: Use HITACHI carbon brush No. 21 indicated in Fig. 20.
5. Replacing carbon brushes:
Disassemble the brush caps (Fig. 1) with a slotted screwdriver. The carbon brushes can
then be easily removed.
6. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE
CENTER, ONLY.
7. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION:
●
Repair, modification and inspection of Hitachi Power Tools must be carried out by a
Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service
Center when requesting repair or other maintenance.
In the operation and maintenance of power tools, the safety regulations and standards
prescribed in each country must be observed.
MODIFICATIONS: Hitachi Power Tools are constantly being improved and modified to
incorporate the latest technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be
changed without prior notice.
16
No. of carbon brush
Wear limit
21
0.20" (5mm)
0.47" (12mm)
Fig. 20