Cutter Blade Assembly And Disassembly And; Adjustment Of Cutter Blade Height - Hitachi P 20SB Mode D'emploi Et Instructions De Securite

English
The planer must always be kept flat throughout the entire cutting operation.
Fig. 4 Beginning of cutting operation
4. Precaution after finishing the planing operation:
When the planer is suspended with one hand after finishing the planing operation,
ensure that the cutting blades (base) of the planer do not contact or come too near your
body. Failure to do so could result in serious injury.

CUTTER BLADE ASSEMBLY AND DISASSEMBLY AND

ADJUSTMENT OF CUTTER BLADE HEIGHT

WARNING:
●
●
1. Cutter blade disassembly:
(1) As shown in Fig. 6 use the accessory box wrench
to withdraw the three bolts used to retain the
cutter blade, and remove the cutter blade holder.
(2) As shown in Fig. 7 slide the rear side of the cutter
blade in the direction indicated by the arrow to
disassemble the cutter blade.
12
Be sure to switch power OFF and disconnect the plug from the recep-
tacle to avoid serious trouble.
Be careful not to injure your hands.
Fig. 5 End of cutting operation
Box wrench
Bolt
Fig. 6
Fig. 7
Blade
holder