Hitachi P 20SB Mode D'emploi Et Instructions De Securite page 13

CAUTION:
● It is not necessary to disassemble the back metal
from the cutter blade. (See Fig. 8)
●
Disassembling the back metal from the cutter
blade is to be made only at grinding the cutter
blade.
2. Cutter blade assembly:
CAUTION
● Prior to assembly, thoroughly wipe off all swarf
accumulated on the cutter blade.
(1) Turn the cutter block flat surface sideways, and
assemble the adjusted cutter blade as shown in
Fig. 9. Ensuring that the leaf spring on the cutter
block is correctly fitted to the hole on the rear plate,
push the back of the cutter blade with a fingertip
in the direction indicated by the arrow, until the
edge of the back metal is properly fitted to the
cutter block surface.
Correct installation is illustrated in Fig. 10.
Fig. 10 (Correct installation)
(2) Place the blade holder on the completed assembly,
as shown in Fig. 12, and fasten it with the three
bolts. Ensure that the bolts are securely tightened.
(3) Turn the cutter block over, and set the other side
in the same manner.
3. Adjustment of cutter blade height:
CAUTION:
● As the set gauge has been accurately factory
adjusted, never attempt to loosen it.
(1) After attaching the back metal to the cutter
blade, temporarily fasten them together with
machine screws, as shown in Fig. 13.
Machine screw
Back metal
Fig. 8
Surface cutter block
Fig. 9
Fig. 11 (Erroneous installation)
Blade holder
Fig. 12
Fig. 13
English
Cutter blade
Edge of
back metal
Machine
screw
13