Installation In Kitchen - M-system MCGW30IX Mode D'emploi

INSTALLATION IN KITCHEN

CABINET WITH DOOR
It is recommended that a 30 mm clear-
ance be left between the cooker top and
the fixture surface beneath it (fig. 4.3).
FASTENING THE COOKTOP
(fig. 4.4)
Each cooktop is supplied with a set of
tabs and screws to fasten it on units with
a working surface from 2 to 4 cm deep.
The kit includes 4 tabs "A" and 4 self-
threading screws "B".
Cut the unit.
Stretch gasket "C" over the edge of the
hole made, being careful to overlay the
junction edges.
Turn the cooktop over and put tabs "A"
into the mountings; only tighten screws
"B" a few turns.
Make sure that the tabs are mounted
correctly as shown in the figure.
Put the cooktop into the hole cut into
the unit and position it correctly.
Put tabs "A" into place and tighten
screws "B" until the cooktop is
completely secured.
Using a sharp tool cut off the part of
gasket "C" which protrudes from the
cooktop.
104
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
(fig. 4.3)
Fig. 4.4
Fig. 4.5
Clearance
Door
Space for
connections
A
A
A
C
A
B
Fig. 4.3
A