M-system MCGW30IX Mode D'emploi page 103

4
4
TECHNICAL INFORMATION
FOR THE INSTALLER
Before installing the cooktop, remove the
protective film.
This cooktop can be built into a working
surface 20 to 40 mm thick and 600 mm
deep.
In order to install the cooker top into the
kitchen fixture, a hole with the dimensions
shown in figs. 4.2a - 4.2b has to be made,
keeping in consideration the following:
– within the fixture, between the bottom
side of the cooker top and the upper
surface of any other appliance or inter-
nal shelf there must be a clearance of at
least 30 mm;
– the cooker top must be kept no less
than 100 mm away from any side wall;
– the cooker top must be kept at a dis-
tance of no less than 50 mm from the
rear wall.
– there must be a distance of at least 650
mm between the hob and any wall cup-
board or extractor hood positioned
immediately above (see fig. 4.1)
– the coatings of the walls of the unit or
appliances near the cooktop must be
heat resistant ("Y" protection against
heating in compliance with standards
EN 60335-2-6).
INSTALLATION
Fig. 4.2a
Fig. 4.1
Fig. 4.2b
103