Dometic Origo 1500 Notice D'utilisation page 18

Mounting the stove
Installing Origo6000 and 6200 (fig. 6, page 5)
7.3
A
NOTICE! Danger of damaging the device!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Determine the best position for the pivot points by placing the range in the
desired position.
➤ Open the stovetop.
➤ Mark the fixing points through the holes in the gimbal sideplates (1).
➤ Remove the range.
➤ Fasten the gimbal arms (2) with fibre washers and screws removed.
➤ Fit one fibre washer with round hole (3) on each gimbal arm (2).
➤ Lift the range in-between gimbal arms (2) so that the gimbal sideplates will spring
into place on the gimbal arms (2).
➤ With open stovetop fit the fibre washers with oblong holes (4) to the gimbal
arm (2).
Ensure they fit properly on the gimbal arms (2) so they can't rotate.
➤ Fit steel washers (5), screws (6) and tighten.
➤ Adjust the tension of the screws to desired friction.
➤ Place a class B-1 fire extinguisher in reaching distance.
7.4 Installing Origo6100
A
NOTICE! Danger of damaging the device!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Make a cutout with the following dimensions (W x H x D): 490 x 530 x 400 mm.
➤ Place the oven into the cutout.
➤ Fix the oven.
➤ Place a class B-1 fire extinguisher in reaching distance.
18
Origo
EN