Dometic Origo 1500 Notice D'utilisation page 17

Origo
Installing the stove (fig. 5, page 5)
7.2
A
NOTICE! Danger of damaging the device!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
If you don't use gimbals, mount the stove as follows:
➤ Drill through the markings in the stove bottom.
➤ Fasten the stove through the holes in place.
The manufacturer recommends the use of gimbals to mount Origo1500 or 3000
(accessory). Mount the gimbals as follows:
➤ Fasten the gimbal sideplates (1) to the lower body of the stove (3) using the
enclosed nuts and bolts.
I
NOTE
The gimbal arms (2) can be turned to enable the stove (3) to be lowered
forwards or backwards.
➤ Before mounting the gimbal arms (2), make a test by attaching them to the gim-
bal sideplates (1) in order to determine which alternative is right for your boat.
Remember, when the gimbals are in down position, the stovetop must be raised
to full upright position in order to remove the fuel canisters for filling.
Ensure the installation is done according to fig. 5, page 5.
➤ Place the fibre washers (4) with round holes on the gimbal arms (2).
➤ Lift the stove into position.
➤ Place the fibre washers (5) with oblong holes on the gimbal sidearms (2).
➤ Fasten the screws (6).
➤ Adjust the tension of the screws to the desired friction.
➤ Place a class B-1 fire extinguisher in reaching distance.
EN
Mounting the stove
17