Technical Data; Before Putting The Machine Into Operation - EINHELL RT-TS 2031 U Mode D'emploi D'origine

Anleitung_RT_TS_2031_U_SPK1:_
also imperative to observe the accident prevention
regulations in force in your area. The same applies
for the general rules of health and safety at work.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of work-
pieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

AC motor
Power P S1 1200 W S6 20% 2000 W
Idle speed n
0
Carbide saw blade
Number of teeth
Bench size
Cutting height max.
Height adjustment
Tilting saw blade
Extractor socket
Weight
09.07.2010 8:04 Uhr
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L
WA
K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
„Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
6. Before putting the machine into
operation
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base.
230 V 50Hz
All covers and safety devices have to be
properly fitted before the machine is switched
on.
2800 min -1
It must be possible for the saw blade to run
Ø 315 x Ø 30 x 3.6 mm
freely.
24
When working with wood that has been
800 x 550 mm
processed before, watch out for foreign bodies
such as nails or screws etc.
83 mm/0°
Before you actuate the On/Off switch, make sure
60 mm / 45°
that the saw blade is correctly fitted and that the
infinite 0 -83 mm
machine's moving parts run smoothly.
infinite 0° - 45°
Before you connect the machine to the power
supply, make sure the data on the rating plate is
Ø 100 mm
the same as that for your mains.
52 kg
Seite 17
sound power level
uncertainty
GB
Idling
103,5 dB(A)
3 dB
92,9 dB(A)
3 dB
17