Table Des Matières; Regulatory Information; Technical Data - Jøtul C 24 Manuel D'installation Et D'utilisation

Table of contents
1.0 Regulatory information ........................... 3
2.0 Technical data ......................................... 3
3.0 Safety ....................................................... 7
4.0 Installation .............................................. 7
5.0 Daily use ................................................ 18
6.0 Servicing ................................................ 20
7.0 Maintenance .......................................... 21
8.0 Optional Equipment ............................. 21
9.0 Recycling ............................................... 21
10.0 Guarantee terms .................................... 21
Register your fi replace at jotul.com for a
25-year warranty.
On all our products there is a
Product:
Jøtul
label indicating the serial number
Room heater fired by solid fuel
and year. Write this number in the
Standard :
Minimum distance to adjacent combustible materials:
place indicated in the installation
Minimum distance to adjacent combustible materials:
Emission of CO in combustion products
:
Flue gas temperature :
Nominal heat output instructions.
:
Efficiency :
Operation range
:
Fuel type :
Operational type :
The appliance can be used in a shared flue.
Always quote this serial number
Country Classification Certificate/ Approved by
when contacting your retailer or
standard
Norway Klasse II
Jøtul.
SP Sveriges Provnings- och
Sweden SP
OGC
Forskningsinstitut AB
SP Swedish National
Testing and Research
EN
EUR Intermittent
Institute
Follow user`s instructions. Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlenen Brennstoffen.
Respectez les consignes d'utilisation. Utilisez uniquement
les combustibles recommandés.
Serial no: Y-xxxx, Year: 200x
Manufacturer: 221546
Jøtul AS
POB 1441
N-1602 Fredrikstad
Norway
Serial no.
1.0 Regulatory
information
Installation of a fi replace must be according to local codes
and regulations in each country.
All local regulations, including those that refer to national
and European standards, shall be complied with when
installing the product.
Both an installation manual with technical data and a general
user and maintenance manual accompany the product. The
installation can only be taken into use after it has been checked
by a qualifi ed inspector.
An approval label made of heat resistant material is located
on the heat shield at the back of the product. This contains
information about identifi cation and documentation for the
product.

2.0 Technical data

Material:
Finish:
Type of fuel:
Max. log length:
Smoke outlet:
Flue pipe dimension:
Outside air connector:
2 connectors for
hot air outlet:
Weight:
Optional extras:
Product dimensions, distances:
Technical data in accordance with 13229
Nominal heat output:
Flue gas fl ow rate:
Recommended chimney draught:
Effi ciency:
CO emissions (13% O2):
OGC emissions (13% O2)
Dust emissions
Flue gas temperature:
Operation:
Intermittent operation means normal use of a fi replace. This
means that to refuel the fi re, you add more wood as soon as
the previous load of wood has burned down to embers.
ENGLISH
Cast iron
Black paint
Wood
50 cm
Top
Ø 150 mm/177 cm2 cross
section
Flexible aluminium pipe
Ø80 mm/Ø100 mm
Flexible aluminium pipe Ø
150 mm
Approx. 136 kg
Frame wide, Fan, outside
air connection kit Ø 100
mm, Adaptorfor fl ue pipe.
See Fig. 1
7.0 kW
5.9 g/s
12 Pa
78%@7.0 kW
0.06%
32 mg/Nm3
5 mg/Nm3
295°C
Intermittent
3